50A 1000V high current pinout single-phase bridge rectifiers KBPC5010W
Description
A bridge rectifier is an array of semiconductor diodes configured as a bridge that acts to change AC (alternating current) to full-wave pulsating DC (direct current). When AC current is connected across one diagonal, DC current is available across the other diagonal. The four diodes allow full-wave rectification without the need for a center-tap on the transformer.
Bride rectifiers are classified into several types based on these factors: type of supply, controlling capability, bride circuit’s configurations, etc. Bridge rectifiers are mainly classified into single and three phase rectifiers. Both these types are further classified into uncontrolled, half controlled and full controlled rectifiers.
Features:
• Metal case for maximum heat dissipation
• Surge overload ratings-400 Amperes
• Low forward voltage drop
Mechanical data:
• Case: Metal, electrically isolated
• Epoxy: UL 94V-0 rate flame retardant
• Lead: MIL-STD-202E, Method 208 guaranteed
• Polarity: As marked
• Mounting position: Any
• Weight: 30 grams
Application:
It is used in many electronic devices including laptop computers, cellular phones and PDA's. Depending on how you're viewing the electronic component.
Advantage:
The main advantage of this bridge circuit is that it does not require a special centre tapped transformer, thereby reducing its size and cost.
Maximum ratings and electrical characteristics:
Rating at 25℃ ambient temperature unless otherwise specified. Resistive or inductive load,60HZ.
For capacitive load, derate current by 20%
| Characteristics | Symbol | KBPC5010 | Unit |
| Maximum recurrent peak reverse voltage | VRRM | 1000 | V |
| Maximum RMS bridge input voltage | VRMS | 700 | V |
| Maximum DC blocking voltage | VDC | 1000 | V |
| Maximum average forward rectified output current. @Ta=55°C | I(AV) | 50.0 | A |
| Peak forward surage current 8.3ms single half sine-wave super impossed on rated load(JEDEC method) | IFSM | 400 | A |
| Maximum instantaneous forward voltage drop per bridge element at 25A | VF | 1.1 | V |
| Maximum DC reverse current @Ta=25°C at rated DC blocking voltage per element @Ta=100°C | IR | 10.0 500 | uA |
| Rating for fusing(t<8.3ms) | I2t | 664 | A2sec |
| Typical junction capacitance | Cj | 300 | pF |
| Typical thermal resistance | RθJA | 2.2 | ℃/W |
| Operating junction temperature range | TJ | -55~150 | ℃ |
| Storage temperature range | TSTG | -55~150 | ℃ |
NOTES :
1. Measured at 1 MHZ and applied reverse voltage of 4.0 volts
2. Thermal Resistance from Junction to Case per leg.
Dimension:(mm)
Product Tags:
|
|
High Current Diode Bridge Rectifier Pinout 1000V 50A Bridge Rectifier KBPC 5010W Images
|
