2.54mm Pitch Slide DIP Switch , 1～12 Position DIP Switch With Dual In Line Package

2.54mm pitch slide type DIP switch 1～12 positions, dual in-line package

Description:

A DIP switch is a manual electric switch that is packaged with others in a group in a standard dual in-line package (DIP). The term may refer to each individual switch, or to the unit as a whole. This type of switch is designed to be used on a printed circuit board along with other electronic components and is commonly used to customize the behavior of an electronic device for specific situations.

DIP switches are an alternative to jumper blocks. Their main advantages are that they are quicker to change and there are no parts to lose.

Application:

DIP switches have become less common in consumer electronics. Reasons include the trend toward smaller products, the demand for easier configuration through software menus, and the falling price of non-volatile memory. However, DIP switches are still widely used in industrial equipment because they are inexpensive and easy to incorporate into circuit designs, and because they allow settings to be checked at a glance without powering the system on.

They are often used as an alternative to jumpers because they are easier to operate and less likely to get lost.

Electrical:

Mechanical:

Notes:

1. Please keep all switch contacts in their "OFF" position for operations

2. Recommended solder temperature at 250±5℃,3~5 seconds

3. Use 30W iron control temperature at 320℃, the welding time is about 2 seconds

4. Cleaning process: using ultrasonic method can give better results, using steam mode, the temperature should not exceed 51℃.

Dimension:

smd chip resistor

electret condenser microphone

2.54mm Pitch Slide DIP Switch , 1～12 Position DIP Switch With Dual In Line Package Images